Case design #4

New issue

Open

opened 2021-04-18 15:38:16 +00:00 by jannik · 0 comments

jannik commented

2021-04-18 15:38:16 +00:00

Owner

To cut cost and for more fun, a custom housing might be designed. There are no special requirements on the material used for now.

But the thickess of some walls is important because of the potentiometers, buttons and connectors sticking through it:

top plate (main UI): 1.0 to 2.0 mm
front side (headphone jacks): 1.0 to 2.0 mm
back side (XLR line in and out, mains supply): less than 3 mm

Please see the BoM section of the readme for the model numbers of the used connectors, potentiometers and buttons and use their data sheets for the required hole pattern.

To cut cost and for more fun, a custom housing might be designed. There are no special requirements on the material used for now. But the thickess of some walls is important because of the potentiometers, buttons and connectors sticking through it: - top plate (main UI): 1.0 to 2.0 mm - front side (headphone jacks): 1.0 to 2.0 mm - back side (XLR line in and out, mains supply): less than 3 mm Please see the BoM section of the readme for the model numbers of the used connectors, potentiometers and buttons and use their data sheets for the required hole pattern.